Zinc Rich Primer - ELSS 90056

Description:

Thermosetting powder coating based on an epoxy resin. This product contains Zinc for excellent corrosion protection.
Typical Applications:

Primer, functional protective coatings.
Typical Properties:

Film Thickness
Gloss 60'angle (ASTM D-523-89)
Hardness (ASTM D-3363-92A)
Flexibility (ASTM D-1737-89)
Adhesion (ASTM D-3359-95A)
Impact Direct/Indirect (ASTM D-2794-93)
Exterior Durability
Chemical Resistance
Salt Spray (ASTM B117)
Specific Gravity (calculated)

1+mil
1 - 5
3H
1/8 inch
5b (100%)
120 in-lbs
Poor
Very Good - Excellent
4000Hrs < 1/8”
2.8
Application Data:

Epoxies can be applied with either a corona electrostatic powder spray gun at between 60kv - 100kv or a Tribo gun. Expoxies can also be formulated for fluid bed application upon request.
Cure Schedule:

Expoxies can be cured in a direct or indirect gas convection oven, an electric oven, or an Infrared. A combination of any of these ovens is also suitable. Care must be taken with excess heat, as epoxies tend to discolor on over bake.
Standard Cure:     10 Minutes @ 3000f Peak Metal Temperature
Storage:

Product should be stored at temperatures below 800f, in a dry area away from any heat source
Notes:

All tests were performed on Bonderite 1000, iron phosphated panels with a nominal film thickness of 2 mils.
Please refer to the MSDS for safety information.

Any recommendations contained herein or any information given by any IFS COATINGS representative is based on tests and information believed to be accurate. However, since we have no control over the conditions under which our products are transported, stored, handled, or used by purchasers, all recommendations and sales are made on condition that IFS COATINGS will not be held liable for any damages resulting from their use. No representative of ours has any authority to waive or change this provision.

 

partner websites
Click here to visit
Polychem Industries

 

© 2007 IFS Coatings Inc. All rights reserved.