Description:

Thermosetting powder coating based on a blend of epoxy and polyester. Hybrids are designed for interior applications where exterior durability is not required.

Typical Applications:

General Metals

Typical Properties:

Film Thickness
Gloss 60'angle (ASTM D-523-89)
Hardness (ASTM D-3363-92A)
Flexibility (ASTM D-1737-89)
Adhesion (ASTM D-3359-95A)
Impact Direct/Indirect (ASTM D-2794-93)
Exterior Durability
Chemical Resistance
Salt Spray (ASTM B117)
Specific Gravity (calculated)

1.3+ mils
90+
2H
1/8 inch
5b (100%)
160 in-lbs
Poor
Good
1000Hrs < 1/8”
1.55

Application Data:

Hybrids are to be applied with a corona electrostatic powder spray gun at between 60kv – 100 kv. Hybrids can also be formulated for tribo or fluid bed application upon request.

Cure Schedule:

Hybrids can be cured in a direct or indirect gas convection oven, an electric oven, or an Infra red. A combination of any of these ovens is also suitable.
Standard Cure:     10 Minutes @ 400⁰f Peak Metal Temperature

Storage:

Product should be stored at temperatures below 80⁰f, in a dry area away from any heat source

Notes:

All tests were performed on Bonderite 1000, iron phosphated panels with a nominal film thickness of 2 mils.
Lower gloss levels may require higher cure temperatures or longer dwell times.
Please refer to the MSDS for safety information.