Skydrol White - URSF 80020

Description:

Thermosetting polyurethane powder coating. This product has been modified for increased chemical resistance and hardness.
Typical Properties:

Film Thickness
Gloss 60'angle (ASTM D-523-89)
Hardness (ASTM D-3363-92A)
Flexibility (ASTM D-1737-89)
Adhesion (ASTM D-3359-95A)
Impact Direct/Indirect (ASTM D-2794-93)
Exterior Durability
Chemical Resistance
Salt Spray (ASTM B117)
Specific Gravity (calculated)

1.5 mil
85+
3H
1/8 inch
5b (100%)
100 in-lbs
Good
Excellent
1000Hrs < 1/8”
1.5
Application Data:

Polyurethane’s are to be applied with a corona electrostatic powder spray gun at between 60- 100kv.
Cure Schedule:

Polyester TGIC’s can be cured in a direct or indirect gas convection oven, an electric oven, or an Infrared. A combination of any of these ovens is also suitable.
Standard Cure:     10 Minutes @ 4000f Peak Metal Temperature
Storage:

Product should be stored at temperatures below 800f, in a dry area away from any heat source
Notes:

All tests were performed on Bonderite 1000, iron phosphated panels with a nominal film thickness of 2 mils.
Lower gloss levels may require higher cure temperatures or longer dwell times.
Please refer to the MSDS for safety information.

Any recommendations contained herein or any information given by any IFS COATINGS representative is based on tests and information believed to be accurate. However, since we have no control over the conditions under which our products are transported, stored, handled, or used by purchasers, all recommendations and sales are made on condition that IFS COATINGS will not be held liable for any damages resulting from their use. No representative of ours has any authority to waive or change this provision.

 

partner websites
Click here to visit
Polychem Industries

 

© 2007 IFS Coatings Inc. All rights reserved.