Description:

hermosetting powder coating based on an epoxy resin. Epoxies are designed for interior applications where exterior durability is not required. This product has been modified for lower film applications and increased flexibility.

Typical Applications:

unctional protective coatings, decorative applications, laboratory furniture, drum coatings.

Typical Properties:

Film Thickness
Gloss 60'angle (ASTM D-523-89)
Hardness (ASTM D-3363-92A)
Flexibility (ASTM D-1737-89)
Adhesion (ASTM D-3359-95A)
Impact Direct/Indirect (ASTM D-2794-93)
Exterior Durability
Chemical Resistance
Salt Spray (ASTM B117)
Specific Gravity (calculated)

1+ mil
5-10
3H
1/8 inch
5b (100%)
up to 140 in-lbs
Poor
Very Good - Excellent
1000Hrs < 1/8”
1.55

Application Data:

Epoxies can be applied with either corona electrostatic powder spray gun at between 60kv – 100 kv or a Tribo gun. Epoxies can also be formulated for fluid bed application upon request.

Cure Schedule:

Epoxies can be cured in a direct or indirect gas convection oven, an electric oven, or an Infrared. A combination of any of these ovens is also suitable. Care must be taken with excess heat, as epoxies tend to discolor on over bake.
Standard Cure:     10 Minutes @ 375⁰f Peak Metal Temperature

Storage:

Product should be stored at temperatures below 80⁰f, in a dry area away from any heat source

Notes:

All tests were performed on Bonderite 1000, iron phosphated panels with a nominal film thickness of 2 mils.
Lower gloss levels may require higher cure temperatures or longer dwell times.
Please refer to the MSDS for safety information.